How to build a Mini Ramp Shed
HINGES
Figure 8: hinge detail
1. measure the diameter of the round bit of your hinge(h)
2. measure the length of the flat bit (LFB)
3. 1' in from the edge of the tranny wall and the flat bit measure a box that is LFB x radius of h
4. now measure the width of the flat bit of the hinge(WFB), and make the box go down as long as the WFB is
5. chisel this box out
6. do the same for the other 3 corners of the tranny, and the other 3 corners of the flat bit and then screw in the hinges
7. test to see weather the hinges work
DOOR
join the 2 doors you cut earlier together, and then fit them into place do the same with the other doors
ROOF
fold the ramp up, and on top of the structure, lay down 2 sheets of OSB. draw around these with a pencil on the outside of this line screw in some leftover 2x4s and make sure that there is at least one on each side where the pieces of OSB join